Filter
Top Products
Chapter 10 Configuration Commands
ZyWALL (ZyNOS) CLI Reference Guide
79
The following table shows the interfaces assigned to each set number.
Source Starting IP
address,
Ending IP address
Shows the range of source IP addresses of packets to which
the rule applies.
Destination Single IP
address
Shows the destination IP address of packets to which the rule
applies.
Destination IP address,
subnet mask
Shows the destination IP address and subnet mask of packets
to which the rule applies.
Destination Starting IP
address,
Ending IP address
Shows the range of source IP addresses of packets to which
the rule applies.
TCP destination port
number(s)
Shows the destination TCP port of packets to which the rule
applies.
TCP destination port
range(s)
Shows the range of destination TCP port of packets to which
the rule applies.
UDP destination port
number(s)
Shows the destination UDP port of packets to which the rule
applies.
UDP destination port
range(s)
Shows the range of destination UDP ports of packets to which
the rule applies.
Custom dest. TCP/UDP port
name
Shows the name of the custom destination port.
Custom IP protocol name Shows the name of a custom IP service.
Custom ICMP protocol name Shows the name of a custom ICMP service.
ACL rule name Shows the name of this rule.
Table 31 Set-Interface Assignments
SET NUMBER INTERFACE
1 LAN to WAN1
2 WAN1 to L AN
3 DMZ to LAN
4 DMZ to WAN1
5 WAN1 to D MZ
6 LAN to DMZ
7 LAN to LAN
8 WAN1 to WA N1
9 DMZ to DMZ
10 LAN to WLAN
11 WLAN to LAN
12 WAN1 to WLAN
13 WLAN to WAN1
14 DMZ to WLAN
15 WLAN to DMZ
Table 30 config display set <index> rule <rule#>
LABEL DESCRIPTION