Filter
Top Products
ZyWALL (ZyNOS) CLI Reference Guide
165
CHAPTER 22
Wireless Commands
Use these commands to configure wireless settings on the ZyWALL.
22.1 Command Summary
The following section lists the commands for this feature.
Table 81 General Wireless Commands
COMMAND DESCRIPTION M
wlan active <1:on|0:off> Sets 1 to activate the wireless card. R+B
wlan association Displays the wireless client association list. R+B
wlan chid <channel–id> Sets the operating frequency/channel depending on
your particular region.
channel–id: This is a three-digit number. For
example, 001 means the channel 1 while 010
means the channel 10.
R+B
wlan essid <essid> Sets the wireless AP’s SSID. R+B
wlan fraThreshold <256~2346> Sets the fragmentation threshold value. R+B
wlan iapp Displays the Inter Access Point Protocol (IAPP)
information.
R+B
wlan outputpower <0~4> Sets the output power level from 0 (highest power)
to 4 (lowest power).
R+B
wlan radio <1:B Only|2:G
Only|3:B+G|4:A Only>
Sets the wireless radio mode.
1: 802.11b mode only
2: 802.11g mode only
3: 802.11b + 802.11g modes
4: 802.11a mode only.
R+B
wlan rtsThreshold <256~2346> Sets the RTS/CTS threshold value. R+B
wlan removeSTA <mac-address> Disconnects a connected wireless station with the
specified MAC address.
R+B
wlan reset Resets the ZyWALL’s wireless module. R+B
wlan scan Scans the environment and displays a
recommended RF channel which is not used by
other wireless APs in that area. This command
works only when your wireless card is activated.
R+B
wlan ssidprofile set <profile-name> Sets the wireless card to use the specified SSID
profile.
R+B
wlan ssidprofile show Displays the currently active SSID profile. R+B