Filter
Top Products
IES-1000 User’s Guide
4-4 System Commands
4.5.3 Set Contact Command
Syntax:
192.168.1.1 sys> set contact [<name>]
This command allows you to set the name of the contact person for your IES-1000. The previous setting will be
cleared if the command is entered with the name omitted.
4.5.4 Set Location Command
Syntax:
192.168.1.1 sys> set location [<name>]
This command allows you to set the location of your IES-1000. The previous setting will be cleared if the
command is entered with the location omitted.
4.5.5 Set Mode
Syntax:
192.168.1.1 sys> set mode [fast/normal]
where
fast =
makes use of the “tag” subset of the IEEE 802.1Q standard to identify the source port of
a frame and speed traffic through a service gateway.
Normal =
switches packets using a layer two switch (IEEE 801.1D) transparent bridge standard.
Use normal mode when you are using a regular gateway.
This command lets you set the network module into fast or normal mode. Determine which mode you are using by
entering the info command.
Enable fast mode only when you are using a service gateway.
4.6 Secured Host Commands
Allow up to ten remote users to access your IES-1000 via IP addresses you specify.
4.6.1 Secured Host Command
Syntax:
192.168.1.1 sys> secured host [<mode>]
where
<mode> =
"enable" or "disable".
If <mode>= disable (default), then anyone may access your IES-1000.
If <mode>= enable, then only those users with IP addresses specified by you
may access your IES-1000 (refer to the Secured Host Add command).
This command enables/disables the secured host function. To display current secured host settings, simply enter the
command secured host.