Filter
Top Products
IES-1000 User’s Guide
6-2 ADSL Configuration
Note that when you configure an ADSL port, the upstream rate must be less than or equal to the downstream rate.
Note also that the
list port command displays the configured parameters of the ADSL port, while the show
port
command displays the actual rates.
6.4 Default Settings
The default profile always exists and all of the ADSL ports belong to it when the AAM1008 is shipped. The default
profile's name is set to
DEFVAL.
6.4.1 Default Profile Settings
The following are the settings of the default profile.
- Name: DEFVAL
- Profile Status: Active
Downstream ADSL settings:
- Target Signal/Noise Rate: 6 db
- Maximum Signal/Noise Rate: 31 db
- Minimum Signal/Noise Rate: 0 db
- Minimum Transmission Rate: 32 Kbps
- Maximum Transmission Rate: 2048 Kbps
Upstream ADSL settings:
- Target Signal/Noise Rate: 6 db
- Maximum Signal/Noise Rate: 31 db
- Minimum Signal/Noise Rate: 0 db
- Minimum Transmission Rate: 32 Kbps
- Maximum Transmission Rate: 512 Kbps
6.4.2 Other Default Settings
The factory default settings for all ADSL ports of the AAM1008 are
- Encapsulation: RFC 1483
- Multiplexing: LLC-based
- VPI : 0
- VCI : 33
- Enable/Disable State: disabled
- Operational mode: auto