Filter
Top Products
IES-1000 User’s Guide
ADSL Configuration 6-11
6.5.21 Set PVC Command
Syntax:
192.168.1.1 adsl> set pvc <port number> <multiplexing mode> <tx vpi> <tx vci> [<rx
vpi> <rx vci>]
where
<port number> =
port number, from 1 to 8.
<multiplexing mode> =
either “llc” or “vc"
<tx vpi> = the VPI setting of the ADSL port for use with a TX based network
<tx vci> = the VCI setting for the ADSL port for use with a TX based network
<rx vpi> = the VPI setting for the ADSL port for use with Rx based networks
<rx vci> = the VCI setting for the ADSL port for use with Rx based networks
The
<rx vpi> and <rx vci> settings will be equal to those of
<tx vpi>
and <tx vci> if the rx settings
are not configured.
The
set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual ADSL
port.
6.5.22 Set PVCs Command
Syntax:
192.168.1.1 adsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx vpi> <rx
vci>]
where
<multiplexing mode> = either “llc” or “vc”
<tx vpi> = the VPI setting of the ADSL ports for use with a TX based network
<tx vci> = the VCI setting for the ADSL ports for use with a TX based network
<rx vpi> = the VPI setting for the ADSL ports for use with Rx based networks
<rx vpi> = the VCI setting for the ADSL ports for use with Rx based networks
The
<rx vpi> and <rx vci> settings will be equal to those of
<tx vpi>
and <tx vci> if the rx settings
are not configured.
The
set pvcs
command allows you to configure a single PVC for all of the ADSL ports at once.
6.5.23 Show PVC Command
Syntax:
192.168.1.1 adsl> show pvc <port number>
where
<port number> =
port number, from 1 to 8.
The show pvc command allows you to display the PVC parameters of an individual ADSL port.