Filter
Top Products
IES-1000 User’s Guide
ADSL Configuration 6-7
6.5.10 List Port Command
Syntax:
192.168.1.1 adsl> list port <port number>
where
<port number> = port number, from 1 to 8
The
list port command shows the configured maximum upstream/downstream rates, the mode (or standard),
and enable/disable state of an individual ADSL port.
6.5.11 List Ports Command
Syntax:
192.168.1.1 adsl> list ports
The
list ports
command shows the configured maximum rates, modes and states of all ADSL ports.
6.5.12 Set Profile Command
Syntax:
192.168.1.1 adsl> set profile <name> <atur max rate > <atuc max rate> [<atur ...>
<atuc ...>]
<atux ...> = <target margin> <min margin> <max margin> <min rate>
where
<name> =
The name of the profile (up to 32 characters).
<atur max rate> =
The maximum ADSL upstream transmission rate.
<atuc max rate> =
The maximum ADSL downstream transmission rate.
<atur target margin> =
The target ADSL upstream signal/noise margin (0..31db).
<atuc target margin> =
The target ADSL downstream signal/noise margin (0..31db).
<atur min margin> =
The minimum acceptable ADSL upstream signal/noise margin (0..31db).
<atuc min margin> =
The minimum acceptable ADSL downstream signal/noise margin (0..31db).
<atur max margin> =
The maximum acceptable ADSL upstream signal/noise margin (0..31db).
<atuc max margin> =
The maximum acceptable ADSL downstream signal/noise margin (0..31db).
<atur min rate> =
The minimum ADSL upstream transmission rate in Kbps.
<atuc min rate> =
The minimum ADSL downstream transmission rate in Kbps.
ATU-C (
atuc) stands for ADSL Termination Unit-Central and refers to downstream transmission and ATU-R
(
atur) stands for ADSL Termination Unit-Remote and refers to upstream transmission.
The profile is a table that contains information on ADSL line configuration. Each entry in this table reflects a
parameter defined by a manager, which can be used to configure the ADSL line.
Note that the default value will be used for any of the above fields that are omitted.
The upstream rate must be less than or equal to the downstream rate.