Filter
Top Products
IES-1000 User’s Guide
System Commands 4-5
4.6.2 Secured Host Add Command
Syntax:
192.168.1.1 sys> secured host add <host IP>
where
<host IP> =
IP address of a secured host.
This command adds the IP address of a secured host. You may add up to ten IP addresses.
4.6.3 Secured Host Delete Command
Syntax:
192.168.1.1 sys> secured host delete <host IP>
where
<host IP> =
IP address of a secured host.
This command deletes the IP address of a previously added secured host.
4.7 UNIX Syslog Commands
Use UNIX syslog commands to send logs to your UNIX server. If the DSL link is on or goes down, the IES-1000
will send a log to your UNIX server. The table, shown next, indicates what is logged in each case.
Table 4-1 Logs Sent to Your UNIX Server
DSL LINK ON DSL LINK DOWN
port number port number
sequence number sequence number
rate -
If your UNIX server is down these logs will be lost.
4.7.1 Syslog Command
Syntax:
192.168.1.1 sys> syslog [<mode>]
where
<mode> =
enable or disable.
This command enables or disables the sending of logs to your UNIX server. The default is disable (<mode>=
disable). A log is sent if <mode>= enable. To display current settings, do not specify a <mode> .
4.7.2 Syslog Facility Command
Syntax: