Filter
Top Products
IES-1000 User’s Guide
5-4 G.SHDSL Commands
5.2.8 List Port Command
Syntax:
192.168.1.1 gshdsl> list port <port #>
where
<port #> =
port number, from 1 to 8
This command displays information about your line speed, mode state and the line rate parameter of a G.SHDSL
port.
An example is shown next.
192.168.1.1 gshdsl> list port 6
Port=6 Speed(Cmax/Act)=2048/ 0Kbps Mode=auto State=Disabled/Down
where
<Cmax> =
Configured maximum (line speed) in Kbps. The maximum G.SHDSL line speed you
configured. For details about configuring this parameter see section 5.2.10.
<Act> =
The actual G.SHDSL line speed in Kbps.
<Mode> =
Displays “auto” or “fixed” mode. For details about configuring this parameter see section
5.2.10.
<State> =
Displays the state of an individual G.SHDSL port and the G.SHDSL line. If this
parameter is disabled, then the G.SHDSL port and line is forced down. If this parameter
is enabled, then the G.SHDSL port and line may be up or down. See next for more
details.
Table 5-2 List Port Command - <State> Parameter
STATE STATUS
UpEnabled
Down
Disabled Forced down
5.2.9 List Ports Command
Syntax:
192.168.1.1 gshdsl> list ports
This command shows the configured minimum speeds (if applicable), maximum speeds, modes and states of all
G.SHDSL ports.
5.2.10 Set Port Command
Syntax:
192.168.1.1 gshdsl> set port <port #> <Cmax> <mode | Cmin>
where
<port #>=
port number, from 1 to 8.