Filter
Top Products
IES-1000 User’s Guide
6-10 ADSL Configuration
The mode parameter specifies the standard that this port is allowed. When set to auto, the AAM1008 follows
whatever mode is set on the other end of the line.
When the mode is set to auto and the negotiated mode is G.lite, if the configured rates exceed those
allowed by G.lite, the actual rates are governed by G.lite, regardless of the configured numbers.
An example is shown next.
192.168.1.1 adsl> set port 4 debug auto
This command sets ADSL port 4 to have the debug profile. The results of this command are reflected when you use
the list profiles command.
6.5.18 Set Ports Command
Syntax:
192.168.1.1 adsl> set ports <profile name> <oper mode>
where
<profile name> =
The profile that will define the settings of this port.
<oper mode> =
Operational mode; the available choices are glite, gdmt, t1.413, or
auto.
The
set ports command assigns a specific profile to all of the ADSL ports and sets all of the ports to one mode,
or standard. The profile defines the maximum and minimum upstream/downstream rates, the target
upstream/downstream signal noise margins, and the maximum and minimum upstream/downstream acceptable
noise margins of all the ADSL ports.
The mode parameter specifies the standard that this port is allowed. When set to auto, the AAM1008 follows
whatever mode is set on the other end of the line.
When the mode is set to auto and the negotiated mode is G.lite, if the configured rates exceed those
allowed by G.lite, the actual rates are governed by G.lite, regardless of the configured numbers.
6.5.19 Show Port Command
Syntax:
show port <port number>
where
<port number> = port number, from 1 to 8
The show port command shows the line status (up or down), the actual upstream/downstream rates and mode of an
individual ADSL port.
6.5.20 Show Ports Command
Syntax:
192.168.1.1 adsl> show ports
The show ports command shows the line status (up or down), the actual upstream/downstream rates and the
mode of all ADSL ports.