Filter
Top Products
IES-1000 User’s Guide
5-6 G.SHDSL Commands
<port #> =
port number, from 1 to 8.
<multiplexing mode> =
either “llc” or “vc"
<tx vpi> =
the VPI setting of the G.SHDSL port for use with a TX based network.
<tx vci> =
the VCI setting for the G.SHDSL port for use with a TX based network.
<rx vpi> =
the VPI setting for the G.SHDSL port for use with Rx based networks.
<rx vci> =
the VCI setting for the G.SHDSL port for use with Rx based networks.
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx settings
are not configured.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual G.SHDSL
port.
5.2.13 Set PVCs Command
Syntax:
192.168.1.1 gshdsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx
vpi> <rx vci>]
where
<multiplexing mode>=
either “llc” or “vc”.
<tx vpi> =
the VPI setting of the G.SHDSL ports for use with a TX based network.
<tx vci> =
the VCI setting for the G.SHDSL ports for use with a TX based network.
<rx vpi> =
the VPI setting for the G.SHDSL ports for use with Rx based networks.
<rx vpi> =
the VCI setting for the G.SHDSL ports for use with Rx based networks.
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx settings
are not configured.
The set pvcs command allows you to configure a single PVC for all of the G.SHDSL ports at once.
5.2.14 Show PVC Command
Syntax:
192.168.1.1 gshdsl> show pvc <port #>
where
<port #> =
port number, from 1 to 8.
This command allows you to display the PVC parameters of an individual G.SHDSL port
5.2.15 Show PVCs Command
Syntax:
192.168.1.1 gshdsl> show pvcs
This command allows you to display the PVC parameters of all G.SHDSL ports.