Filter
Top Products
IES-1000 User’s Guide
8-4 Bridge Commands
Query Interval 125 seconds
where
ID
The location of the entry in the multicast filtering database.
GDA
Group Destination Address. The IP address of a multicast group destination.
MAC
The last 3 bytes of the multicast MAC that the GDA is mapped to.
Member Ports
The ports that belong to this multicast group. 1= Ethernet, 2= DSL port 1, 3=DSL port
2 and so on.
IGMP version
The version of IGMP being used in the network.
Query Received
The number of query packets received by the IES-1000.
Max Response Time
The longest period of time used to respond to a query packet, measured in tenths of a
second.
Query Interval
The time period between query packets.
8.4.3 Filterage Command
Syntax:
192.168.1.1 bridge> filterage [age]
where
age =
aging out timer period in seconds.
This command sets or shows the aging out timer period of the filtering database. It is recommended that you use the
default setting. If the time interval is set too short, it could increase broadcast traffic and reduce the available
bandwidth.
8.4.4 Flush Command
Syntax:
192.168.1.1 bridge> flush [port]
where
port =
A bridge port number
This command flushes out the filtering database of the specified bridge port. If the <port>
field is omitted, this
command will flush out the filtering databases of all ports.
8.4.5 Info Command
Syntax:
192.168.1.1 bridge> info
This command shows the software number of the bridge implementation and the maximum size of the filtering
database.