Filter
Top Products
IES-1000 User’s Guide
Remote Management 12-3
This command allows read-only or read-write access. If the IP address is specified, access is allowed for the
manager station with that address only.
12.3.2 SNMP Access Delete Command
Syntax:
access delete <community> [<IP addr>]
This command revokes SNMP access by the specified community (password). If the IP address is specified, access
is denied for that manager station only.
12.3.3 SNMP Access Flush Command
Syntax:
access flush
This command revokes access by any and all manager stations.
12.3.4 SNMP Access List Command
Syntax:
access list
This command shows the allowed access.
12.4 SNMP Trap Configuration
The network module uses the SNMP trapping facility to proactively report unusual events to one or more trap
servers. To configure the trap parameters, use the
trap commands in the SNMP subsystem. After configuring the
SNMP trap parameters, save the configuration to the nonvolatile memory with the
config save command.
12.4.1 Supported Traps
The network module supports the following traps
♦ coldStart Trap (defined in RFC 1215) :
This trap is sent at system start-up.
♦ authenticationFailure Trap (defined in RFC 1215) :
This trap is sent if a request arrives with an invalid community string.
♦ linkUp Trap (defined in RFC 1215) :
This trap is sent when a DSL port is up.
♦ linkDown Trap (defined in RFC 1215) :
This trap is sent when a DSL port is down.
♦ overheat Trap (defined in ZYXEL-MIB) :
This trap is sent when a network module is overheated.