Enterasys Networks D2G124-12 Manual

A SERVICE OF

next previous

set spantree priority

D-Series CLI Reference 6-17

set spantree priority

Usethiscommandtosetthedevice’sSpanningTreepriority.

Syntax

set spantree priority priority [sid]

Parameters

Defaults

Ifsidisnotspecified,prioritywillbesetonSpanningTree0.

Mode

Switchcommand,read‐write.

Usage

Thedevicewiththehighestpriority(lowestnumericalvalue)becomestheSpanningTreeroot

device.Ifalldeviceshavethesamepriority,thedevicewiththelowestMACaddresswillthen

becometherootdevice.Dependingonthebridgeprioritymode(setwiththesetspantree

bridgeprioritymodecommanddescribedin“

setspantreebridgeprioritymode”onpage 6‐10,

somepriorityvaluesmayberoundedupordown.

Example

Thisexampleshowshowtosetthebridgepriorityto4096onSID1:

D2(su)->set spantree priority 4096 1

clear spantree priority

UsethiscommandtoresettheSpanningTreeprioritytothedefaultvalueof32768.

Syntax

clear spantree priority [sid]

Parameters

Defaults

Ifsidisnotspecified,prioritywillberesetonSpanningTree0.

Mode

Switchcommand,read‐write.

priority Specifiesthepriorityofthebridge.Validvaluesarefrom0to61440(in

incrementsof4096),with0indicatinghighestpriorityand61440

lowestpriority.

sid (Optional)SetsthepriorityonaspecificSpanningTree.Validvalues

are0‐4094.Ifnotspecified,SID 0is

assumed.

sid (Optional)ResetsthepriorityonaspecificSpanningTree.Validvalues

are0‐4094.Ifnotspecified,SID 0isassumed.