show inlinepower
D-Series CLI Reference 2-31
Commands
Thecommandsusedtoreviewandsetsystempowerparametersarelistedbelow.
show inlinepower
Usethiscommandtodisplaysystempowerproperties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaysystempowerproperties:
D2(su)->show inlinepower
Detection Mode : auto
Unit Status Power(W) Consumption(W) Usage(%) Threshold(%) Trap
---- ------ -------- -------------- -------- ------------ ----
1 auto 480 0.00 0.00 80 enable
set inlinepower threshold
Usethiscommandtosetthepowerusagethreshold.
Syntax
set inlinepower threshold usage-threshold
Parameters
For information about... Refer to page...
show inlinepower 2-31
set inlinepower threshold 2-31
set inlinepower trap 2-32
show port inlinepower 2-32
set port inlinepower 2-33
thresholdvalue Specifiesapowerthresholdasapercentageoftotalsystempowerusage.
Validvaluesare11to100.
