Enterasys Networks D2G124-12 Manual

A SERVICE OF

next previous

clear policy port

D-Series CLI Reference 9-15

Example

ThisexampleshowshowtoallowGigabitEthernetports5through15inslot1totransmitframes

accordingtopolicyprofile1:

D2(su)->set policy port ge.1.5-15 1

clear policy port

Usethiscommandtoremoveapolicyprofilefromoneormoreports.

Syntax

clear policy port port-string profile-index

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

Thisexampleshowshowtoremovepolicyprofile10fromport21inslot1:

D2(rw)->clear policy port ge.1.21 10

Configuring Policy Class of Service (CoS)

TheD‐SeriessupportsClassofService(CoS),whichallowsyoutoassignmission‐criticaldatatoa

higherprioritythroughthedevicebydelayinglesscriticaltrafficduringperiodsofcongestion.

Thehigherprioritytrafficgoingthroughthedeviceisservicedfirst(beforelowerprioritytraffic).

TheClassofService

capabilityofthedeviceisimplementedbyapriorityqueueingmechanism.

ClassofServiceisbasedontheIEEE802.1D(802.1p)standardspecification,andallowsyouto

defineeightpriorities(0‐7,with7grantedhighestpriority)andupto8transmitqueues(0‐7)for

eachport.

Bydefault,policy

‐basedCoSisdisabledonthedevice,anddefaultoruser‐assignedport‐based

802.1D(802.1p)settingsareusedtodeterminetrafficratelimiting.Whenpolicy‐basedCoSis

port‐string Specifiestheport(s)fromwhichtoremovethepolicyprofile.Fora

detaileddescriptionofpossibleport‐stringvalues,refer

to“PortString

SyntaxUsedintheCLI”onpage 4‐1.

profile‐index SpecifiestheIDofthepolicyprofile(role)towhichtheport(s)willbe

added.Thisvaluemustmatchtheprofile‐indexvalueassignedusingthe

setpolicyprofilecommand(“setpolicyprofile”onpage 9‐4)

inorderfor

apolicyprofiletobeactiveonthespecifiedport.

Note: It is recommended that you use Enterasys Networks NetSight Policy Manager as an

alternative to CLI for configuring policy-based CoS on the switches.