Enterasys Networks D2G124-12 Manual

A SERVICE OF

next previous

clear multiauth mode

15-32 Security Configuration

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Usage

MultiauthmultimoderequiresthatMAC,PWA,and802.1Xauthenticationbeenabledglobally,

andconfiguredappropriatelyonthedesiredportsaccordingtotheircorrespondingcommand

setsdescribedinthischapter.Referto“Configuring802.1XAuthentication”onpage 15‐9and

“ConfiguringMACAuthentication”onpage 15‐19and“ConfiguringPortWeb

Authentication

(PWA)”onpage 15‐57.

Example

Thisexampleshowshowtoenablesimultaneousmultipleauthentications:

D2(rw)->set multiauth mode multi

clear multiauth mode

Usethiscommandtoclearthesystemauthenticationmode.

Syntax

clear multiauth mode

Parameters

None.

Defaults

None.

Mode

Switchcommand,read‐write.

Example

Thisexampleshowshowtoclearthesystemauthenticationmode:

D2(rw)->clear multiauth mode

multi Allowsthesystemtousemultipleauthenticatorssimultaneously(802.1x,

PWA,andMACAuthentication)onaport. Thisisthedefaultmode.

strict Usermustauthenticateusing802.1xauthentica tionbeforenormaltraffic

(anythingotherthanauthenticationtraffic)canbeforwarded.