A SERVICE OF

logo

Open as PDF
next previous
1
1-10 Connecting to the Network
Before you begin
The following steps should be completed before you configure the GA-1040 and the
workstations that will print to the GA-1040. A service technician will have performed
some initial installation.
TO PREPARE FOR GA-1040 CONFIGURATION
1. Print a copier test page to make sure the copier is functioning normally.
2. With the copier turned off, connect the network cable to the GA-1040, as described in
the next section.
The network should already be installed and operational.
3. Turn on the copier.
4. Prepare network servers to share GA-1040 user software and to enable networked
users to print to the GA-1040, and proceed to Setup.
See Chapters 2 through 4 for details.