4
4-6 Setting up the GA-1040 from a Windows Computer
Network Setup
Network Setup configures the GA-1040 to receive print jobs over the networks that are
used at your site. If the GA-1040 is configured to enable more than one protocol, it
automatically switches to the correct protocol when it receives a print job. When two
network ports are enabled, print jobs can be received over all of ports at the same time.
You can modify these Network Setup options:
• Ports—Ethernet or parallel port
• Protocols— TCP/IP, AppleTalk, and IPX/SPX
• Print Services—NetWare printing (PServer), Windows print sharing (SMB),
LPD printing (TCP/IP), and HTTP support (WWW)
NOTE: To set up Port 9100 printing, use Setup from TopAccess.
TO CONFIGURE NETWORK PORTS
• Click the Port tab in the Network Setup dialog box.
You can adjust settings as detailed in the following sections.
