1
1-11 Ethernet cable connection
Ethernet cable connection
The GA-1040 supports Ethernet cabling with Unshielded Twisted Pair (UTP) cable
and Shielded Twisted Pair (STP), defined as Category 5 for use with 100BaseT or
defined as Category 3 or Category 5 for use with 10BaseT. The cable plugs into the
RJ-45 socket on the GA-1040.
NOTE: The 100BaseT type supported by the GA-1040 is 100BaseTX, also known as
Fast Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term
“100BaseT” is used in this manual to refer to 100BaseTX.
Back view with GA-1040 installed
Shut down the copier before attaching the GA-1040 to any network device.
TO USE UTP/STP CABLE FOR 100BASET OR 10BASET
1. With the copier turned off, connect the RJ-45 connector to the RJ-45 socket on the
back of the copier.
2. Configure network servers for printing and then proceed to Setup.
Parallel connecto
RJ-45 connector for Etherne
!
