4
4-8 Setting up the GA-1040 from a Windows Computer
TO CONFIGURE THE TCP/IP PROTOCOL
• Click the Protocol1 tab in the Network Setup window.
You can change AppleTalk, IPX/SPX, and TCP/IP protocol settings for the GA-1040
on the Protocol1 and Protocol2 tabs.
The GA-1040 can accept jobs via TCP/IP, AppleTalk, and IPX/SPX simultaneously.
To configure the GA-1040, choose each protocol and enter the settings for that
protocol.
Enable Ethernet. If your network uses a gateway, enter the gateway address.
When you set an IP address, subnet mask, or gateway address for the GA-1040 during
Setup, you can allow the GA-1040 to get these addresses automatically from a DHCP,
BOOTP, or RARP server. First, turn on or reboot the GA-1040 and allow it reach Idle.
Next, make sure the DHCP, BOOTP, or RARP server is running. Finally, perform
GA-1040 Setup.
