Filter
Top Products
Reinstalling System Software Using Recovery Mode
7-30 41-001190-02 Rev. 01, Rel. 1.2
AastraLink Pro 160 Administrator Guide
3 Click the “Advanced” tab.
4 In the “Netconsole Enabled” field, place a checkmark in the box to enabale Netconsole.
5 In the “Netconsole IP” field, enter the IP address of the host on the network where the printk
messages about the kernal are to be stored.
6 In the “Netconsole MAC” field, enter the MAC address of the host on the network where the printk
messages about the kernal are to be stored.
7 Click <Save> to save the information you just entered.
8 After setting the advanced tasks in the previous steps, you must reboot the AastraLink Pro.
Click <Click to Reboot the AastraLink> to reboot the AastraLink.
AastraLink Recovery UI
Step Action