Filter
Top Products
Configuring Groups
41-001190-02 Rev. 01, Rel. 1.2 3-39
Configuring Aastra IP Phone Accounts
Notes:
1. By default, incoming intercom calls are enabled for all IP phone models. If
required, an Administrator can enable outgoing intercom calls on all model
phones (except 51i).
2. The Icom hard key is applicable to the 480i and 480i CT only; all other
model phones (except 51i) can be configured with an Icom softkey.
3. Remote office phones cannot receive paging calls.
• Paging group security - An optional Password allows the administrator to
establish an access PIN code that users are required to enter before sending a
call to a Paging group.
The default 660 all-phones have a permanently enabled password. This group
is the VoIP equivalent of the Overhead Paging port, (see Chapter 4,
“Configuring Overhead Paging” on page 4-49) and shares the password
configured for that feature.
Note: If the incoming "Barge-in" setting is disabled, or the incoming
"Auto-Answer" is disabled on the phone, the page does not go to the
speakerphone.
Dial Plan for Ring Groups
AastraLink Pro 160 dialplan provides access to Ring Groups using the "65"
prefix.
When configuring Ring Groups using the WebUI, AastraLink automatically
prepends the “65” digits to the groups’s extension, to create a virtual extension
number. For example, creating a Ring Group 300 will automatically prefix 65 so
that the dial plan entry becomes 65300.
For more information about dial plans and for a table of dial plan numbers, see
Chapter 4, Table 4-1 “AastraLink Pro 160 Dialplan” on page 4-40).
Note: All phones, including DECT handsets (420d) and FXS phones are
supported for Ring Groups.