Filter
Top Products
MAINTENANCE
ERROR MESSAGE
AND DESCRIPTION
POSSIBLE SOLUTION
Port CP Missing But
Check CP slot; reseat CP; change
“Administered:
(Other than CP; or remove
CP
from
CPU/Memory) Translated port CP
translations. If CP does not pass
that CPU cannot access. power-up, replace CP.
Port CP Out Of Service:
(Other
If the CP has not been removed
than CPU/Memory)
Message and the problem persists, check
occurs when a CP is removed
or replace the port CP.
from a cabinet. Error removed
when the CP passes power-up.
Port CP ROM Checksum Failure:
Try reseating the CP. If this error
The port CP has found that the
happens again, then replace the
checksum on its firmware is bad. CP.
Port Buffer Full:
(STARLAN
If the reset is not successful,
Interface CP) This error resets the
reseat CP. If the reseat fails,
CP.
replace the CP.
Port Fault: For an auxiliary trunk, Check wiring of
external
this message is logged when a equipment (see Figure 4-7).
ground is expected from external
equipment and is not detected.
Port Queue Full:
(STARLAN
If the reset is not successful,
Interface CP) This error resets the
reseat CP. If the reseat fails,
CP.
replace the CP.
Program
Logic
Inconsistent: Reseat CP. If problem persists,
(Other
than CPU/Memory)
replace it.
Possible hardware problem on
port CP.
RAM Test Failed: CPU/Memory Check CPU/Memory CP.
CP has failed the RAM test.
4-42