Filter
Top Products
62 E1442A Command Reference Chapter 3
Example Enabling Continuous Scans
,1,7&21721
Enables continuous scanning
6&$1#
Sets channel list
,1,7
Starts scanning cycle
INITiate:CONTinuous?
INITiate:CONTinuous? queries the scanning state. With continuous
scanning enabled, the command returns 1. With continuous scanning
disabled, the command returns 0.
Example Query Continuous Scanning State
,1,7&21721
Enable continuous scanning
,1,7&217"
Query continuous scanning state
INITiate[:IMMediate]
INITiate[:IMMediate] starts the scanning cycle and closes the first channel
in the channel list. Successive triggers from the source specified by the
TRIGger:SOURce command advance the scan through the channel list.
Comments Starting the Scanning Cycle: The INITiate[:IMMediate] command
starts scanning by closing the first channel in the channel list. A trigger
advances the scan through the channel list. An invalid channel list
generates an error (see [ROUTe:]SCAN command).
Stopping Scanning Cycles: See the ABORt command.
Related Commands: ABORt, ARM:COUNt, INITiate:CONTinuous,
TRIGger, TRIGger:SOURce
*RST Condition: None
Example Starting a Single Scan
6&$1#
Sets channel list
,1,7
Starts scanning cycle by closing
channel 00 and proceeding