Filter
Top Products
74 E1442A Command Reference Chapter 3
STATus:OPER:CONDition?
STATus:OPERation:CONDition? returns the state of the Condition
Register in the Operation Status Group. The state represents conditions
which are part of the instrument’s operation. The SWITCH driver does
not set bit 8 in this register (see STAT:OPER:EVENt?).
STATus:OPERation:ENABle
STATus:OPERation:ENABle <number> sets an enable mask to allow
events recorded in the Event Register to send a summary bit to the
Status Byte Register (bit 7). For Form C switch modules, when bit 8 in
the Operation Status Register is set to 1 and that bit is enabled by the
OPER:ENABle command, bit 7 in the Status Register is set to 1.
Parameters
Comments Setting Bit 7 of the Status Register: STATus:OPERation:ENABle 256 sets
bit 7 of the Status Register to 1 after bit 8 of the Operation Status
Register is set to 1.
Related Commands: [ROUTe:]SCAN
Example Enable the Status Register
67$723(5(1$%
Enables bit 8 of the Operation
Status Register to be reported to
bit OPR in the Status Register
STATus:OPERation:ENABle?
STATus:OPERation:ENABle? returns which bits in the Event Register
(Operation Status Group) are unmasked.
Comments Output Format: Returns a decimal weighted value from 0 to 65,535
indicating which bits are set to true. The value returned is the value set
by STAT:OPER:ENAB <number> command. However, the maximum
decimal weighted value used in this module is 256 (bit 8 set to true).
Example Query the Operation Status Enable Register
67$723(5(1$%"
Query the Operation Status
Enable Register
Name Type Range of Values Default Value
<number> numeric
0 through 65535
N/A