Filter
Top Products
102 Index
D
declaration of conformity, 9
detecting error conditions
, 46
device type register, reading
, 91
DISPlay MONitor CARD
, 58
DISPlay MONitor CARD?
, 59
DISPlay MONitor STATe
, 59
DISPlay MONitor STATe?
, 60
DISPlay subsystem
, 58
documentation history
, 8
E
E1442A command reference, 51
error conditions, detecting
, 46
error messages
, 99–100
error types
, 99
examples
Advancing Scan Using TRIGger
, 79
Check Device Driver
, 39
Closing Form C Switch Channels
, 67
Common Terminal Pullup Configuration
, 32
Differential Divider or Filter Configuration
, 36
Divider with Filter Configuration
, 35
Enable the Status Register
, 74
Enabling Continuous Scans
, 62
Enabling the Monitor Mode
, 60
Enabling Trig Out Port
, 64
Error Checking Using Interrupts
, 47
Error Checking Using Polling
, 46
Low-Pass Filter Configuration
, 31
Normally Closed Terminal Pullup Config
, 33
Normally Open Terminal Pullup Configuration
, 34
Open, Close, and Scan Operations
, 40
Opening Form C Switch Channels
, 68
Query Continuous Scanning State
, 62
Query Form C Switch Channel Closure
, 67
Query Form C Switch Channel Open State
, 68
Query Module Identity
, 40
Query Number of Scanning Cycles
, 57
Query the Operation Status Enable Register
, 74
Query Trig Out Port
, 64
Query Trigger Source
, 81
Reading a Card Description
, 76
Reading Card Model Number
, 77
Reading the Error Queue
, 78
Reading the Operation Status Register
, 75
Register-Based Programming
, 96
Resistor Divider Configuration
, 30
E (continued)
examples (cont’d)
Scanning Using Bus Triggers
, 81
Scanning Using External Devices
, 69
Scanning Using External Triggers
, 81
Scanning Using Trig Out and Trig In Ports
, 49
Scanning With External Device
, 48
Select Module #2 for Monitoring
, 58
Set Power-On State
, 77
Setting a Logical Address
, 18
Setting Ten Scanning Cycles
, 56
Starting a Single Scan
, 62
Stopping a Scan with ABORt
, 55
Straight-Through Configuration
, 29
Synchronizing the Form C Switch
, 50
System Error Checks
, 41
Using the Scan Complete Bit
, 45
I
ID register, reading, 91
IEEE 488.2 commands reference
, 83
implied commands
, 52
INITiate CONTinuous
, 61
INITiate CONTinuous?
, 62
INITiate IMMediate
, 62
INITiate subsystem
, 61
installing the switch
, 23
internal buses, setting
, 21
interrupt priority, setting
, 20
L
logical address, setting, 18
O
offset, register, 89
Option 010 terminal module
, 27
OUTPut ECLTrgn STATe
, 63
OUTPut ECLTrgn STATe?
, 63
OUTPut EXTernal STATe
, 64
OUTPut EXTernal STATe?
, 64
OUTPut subsystem
, 63
OUTPut TTLTrgn STATe
, 65
OUTPut TTLTrgn STATe?
, 65
P
parameters, 53
programming the switch
, 37
programming, register-based
, 87