Filter
Top Products
To setup RIP for the IP interfaces configured on the Switch,the user must enable RIP and then configure RIP settings for the individual IP interfaces.To globally
enable RIP on the Switch,open the Configuration folder to Layer 3 Networking and then open the RIP folder and click on the RIP Configuration
link to access the following screen:
Figure 6- 95.RIP Global Setting window
To enable RIP,simply use the pull down menu,select
Enabled and click Apply.
Setting Up RIP
RIP settings are configured for each IP interface on the Switch.Click the RIP Interface Settings link in the RIP folder.The menu appears in table form listing
settings for IP interfaces currently on the Switch.To configure RIP settings for an individual interface,click on the hyperlinked
Interface Name.To view the
next page of RIP Interface Settings,click the
Next button.
Figure 6- 96.RIP Interface Settings window
Click the hyperlinked name of the interface you want to set up for RIP,which will give access to the following menu:
Figure 6- 97.RIP Interface Settings – Edit window
Refer to the table below for a description of the a
vailable parameters for RIP interface settings.
The following RIP settings can be a
pplied to each IP interface:
102
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch