Filter
Top Products
The following parameters can be set,for the Ethernet type:
Parameter Description
Profile ID (1-8)
Type in a unique identifier number for this profile set.This value can be set from 1 - 8.
Type Select profile based on Ethernet (MAC Address),IP address or packet content mask.This will change the menu
according to the requirements for the type of profile.
Select
Ethernet to instruct the Switch to examine the layer 2 part of each packet header.
Select IP to instruct the Switch to examine the IP address in each frame's header.
Select
Packet Content Mask to specify a mask to hide the content of the packet header.
VLAN Selecting this option instructs the Switch to examine the VLAN identifier of each packet header and use this as
the full or partial criterion for forwarding.
Source MAC Source MAC Mask – Enter a MAC address mask for the source MAC address.
Destination MAC Destination MAC Mask – Enter a MAC address mask for the destination MAC address.
802.1p Selecting this option instructs the Switch to examine the 802.1p priority value of each packet header and use
this as the, or part of the criterion for forwarding.
Ethernet type Selecting this option instructs the Switch to examine the Ethernet type value in each frame's header.
Port The user may set the Access Profile Table on a per-port basis by entering a port number in this field.The port
list is specified by listing the lowest switch number and the beginning port number on that switch,separated by
a colon.Then the highest switch number,and the highest port number of the range (also separated by a colon)
are specified.The beginning and end of the port list range are separated by a dash.For example, 1:3 specifies
switch number 1,port 3.2:4 specifies switch number 2,port 4.1:3 -2:4 specifies all of the ports between switch
1,port 3 and switch 2,port 4 • in numerical order.Entering all will denote all ports on the Switch.
The page shown below is the
IP Access Profile Configuration page.
Figure 6- 62.Access Profile Configuration (IP)
The f
ollo
wing parameters can be set,
f
or
IP:
Parameter Description
Profile ID (1-8) Type in a unique identifier number for this profile set.This value can be set from 1 - 8.
T
ype
Select pr
ofile based on Ethernet (MA
C
Address),IP address or packet content mask.This will change the menu
accor
ding to the r
equir
ements f
or the type of pr
ofile
.
Select
Ethernet to instruct the Switch to examine the layer 2 part of each packet header.
Select
IP to instruct the Switch to examine the IP address in each frame's header.
Select Packet Content Mask to specify a mask to hide the content of the packet header.
VLAN Selecting this option instructs the Switch to examine the VLAN part of each packet header and use this as the,
or par
t of the criterion f
or f
orwarding.
77
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch