Filter
Top Products
Figure 6- 70.Access Rule Table (Packet Content Mask)
To remove a previously created rule,select it and click the ✘ button.To add a new Access Rule, click the Add button:
Figure 6- 71.Access Rule Configuration – Packet Content Mask
To set the Access Rule for the
Packet Content Mask,adjust the following parameters and click Apply.
Parameter Description
Pr
ofile ID
This is the identifier n
umber f
or this pr
ofile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch,according
to any additional rule added (see below).
Select
Deny to specify that packets that do not match the access profile are not forwarded by the Switch and
will be filter
ed.
Access ID T
ype in a unique identifier number for this access.This value can be set from 1 - 50.
Type Selected pr
ofile based on Ethernet (MA
C
Ad
dr
ess),IP address or Packet Content Mask.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
P
ac
k
et Content Mask
instructs the Switch to examine the pack
et header
.
83
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch