Filter
Top Products
DVMRP Interface Configuration
The Distance Vector Multicast Routing Protocol (DVMRP) is a hop-based method of building multicast delivery trees from multicast sources to all nodes of a
network.Because the delivery trees are ‘pruned’ and ‘shortest path’,DVMRP is relatively efficient.Because multicast group membership information is forwarded
by a distance-vector algorithm,propagation is slow. DVMRP is optimized for high delay (high latency) relatively low bandwidth networks,and can be considered as
a ‘best-effort’ multicasting protocol.
DVMRP resembles the Routing Information Protocol (RIP),but is extended for multicast delivery.DVMRP builds a routing table to calculate ‘shortest paths’ back
to the source of a multicast message, but defines a ‘route cost’ (similar to the hop count in RIP) as a relative number that represents the real cost of using this
route in the construction of a multicast delivery tree to be ‘pruned’ – once the delivery tree has been established.
When a sender initiates a multicast,DVMRP initially assumes that all users on the network will want to receive the multicast message.When an adjacent router
receives the message, it checks its unicast routing table to determine the interface that gives the shortest path (lowest cost) back to the source. If the multicast
was received over the shortest path,then the adjacent router enters the information into its tables and forwards the message.If the message is not received on
the shortest path back to the source,the message is dropped.
Route cost is a relative number that is used by DVMRP to calculate which branches of a multicast delivery tree should be ‘pruned’.The ‘cost’ is relative to other
costs assigned to other DVMRP routes throughout the network.
The higher the route cost,the lower the probability that the current route will be chosen to be an active branch of the multicast delivery tree (not ‘pruned’) – if
there is an alternative route.
DVMRP Global Setting
To enable DVMRP globally on the Switch,open the IP Multicast Routing Protocol folder in the Configuration folder,and click the DVMR
Configuration
link.This will give the user access to the following screen:
Figure 6- 132.DVMRP Global Settings window
Use the pull down menu,choose Enabled,and click Apply to implement the DVMRP function on the Switch.
DVMRP Interface Settings
To view the DVMRP Interface Table,open the IP Multicasting folder under Configuration and click DVMRP Interface Settings.This menu
allows the
Distance-Vector Multicast Routing Protocol (DVMRP) to be configured for each IP interface defined on the Switch.Each IP interface
configur
ed on the Switch is displayed in the below
D
VMRP Interface Configuration
dialog bo
x.To configure DVMRP for a particular interface,click the
corresponding hyperlink for that IP interface.This will open the
DVMRP Interface Configuration window:
Figure 6- 133.DVMRP Interface Settings window
Figur
e 6- 134.
D
VMRP Interface Settings – Edit windo
w
130
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch