Filter
Top Products
Parameter Description
User Name Enter a User Name of no more than 15 characters to identify the SSH user.This User Name must be a
previously configured user account on the Switch.
Auth. Mode The administrator may choose one of the following to set the authorization for users attempting to access the
Switch.
Host Based – This parameter should be chosen if the administrator wishes to use a remote SSH server for
authentication purposes.Choosing this parameter requires the user to input the following information to
identify the SSH user.
Host Name – Enter an alphanumeric string of no more than 32 characters to identify the remote SSH
user.
Host IP – Enter the corresponding IP address of the SSH user.
Password – This parameter should be chosen if the administrator wishes to use an administrator-defined
password for authentication.Upon entry of this parameter,the Switch will prompt the administrator for a
password,and then to re-type the password for confirmation.
Public Key – This parameter should be chosen if the administrator wishes to use the publickey on a SSH server
for authentication.
Host Name Enter an alphanumeric string of no more than 32 characters to identify the remote SSH user.This parameter is
only used in conjunction with the Host Based choice in the Auth.Mode field.
Host IP Enter the corresponding IP address of the SSH user.This parameter is only used in conjunction with the Host
Based choice in the
Auth.Mode field.
Click
A
pply
to implement changes made
.
Note: To set the SSH User Authentication parameters on the Switch,a User Account must be previously configured.For more information
on configuring local User Accounts on the Switch,see the
User Accounts section of this manual located in this section.
148
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch