Filter
Top Products
Figure 10- 5.Firmware Information window
This window holds the following information:
Parameter Description
BOX
States the stacking ID number of the switch in the switch stack.
ID States the image ID number of the firmware in the Switch’s memory.The Switch can store 2 firmware images
for use.Image ID 1 will be the default boot up firmware for the Switch unless otherwise configured by the user.
Version States the firmware version.
Size States the size of the corresponding firmware, in bytes.
Update Time States the specific time the firmware version was downloaded to the Switch.
From States the IP address of the origin of the firmware.There are four ways firmware may be downloaded to the
Switch.
R – If the IP address has this letter attached to it,it denotes a firmware upgrade through the Console Serial
Port (RS-232).
T – If the IP address has this letter attached to it,it denotes a firmware upgrade through Telnet.
S – If the IP address has this letter attached to it,it denotes a firmware upgrade through the Simple Network
Management Protocol (SNMP).
W – If the IP ad
dr
ess has this letter attached to it,it denotes a firmware upgrade through the web-based
management interface.
User States the user who downloaded the firmware.This field may read “Anonymous” or “Unknown” for users that
are not identified.
Config Firmware Image
The Config Firmware Image window allows users to configure firmware images saved in the memory of the Switch.To access the following window, click
Maintenance > MULTIPLE IMAGE Services > Config Firmware Image.
Figure 10- 6.Config Firmware Image window
186
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch