Filter
Top Products
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch,according
to any additional rule added (see below).
Select
Deny to specify that packets that do not match the access profile are not forwarded by the Switch and
will be filtered.
Access ID Type in a unique identifier number for this access.This value can be set from 1 - 50.
Type Selected profile based on Ethernet (MAC Address), IP address or Packet Content Mask.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header
Priority (0-7) This parameter is specified if you want to re-write the 802.1p default priority previously set in the Switch,
which is used to determine the CoS queue to which packets are forwarded to.Once this field is specified,
packets accepted by the Switch that match this priority are forwarded to the CoS queue specified previously by
the user.
Replace priority with – Click the corresponding box if you want to re-write the 802.1p default priority of a
packet to the value entered in the
Priority field,which meets the criteria specified previously in this
command,before forwarding it on to the specified CoS queue. Otherwise, a packet will have its incoming
802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues,CoS queues and mapping for 802.1p,see the
QoS section of this
manual.
VLAN Name Allows the entry of a name for a previously configured VLAN.
Source MAC Source Enter a MAC Address for the source MAC address.
Destination MAC Destination Enter a MAC Address mask for the destination MAC address.
802.1p (0-7) Enter a value from 0-7 to specify that the access profile will apply only to packets with this 802.1p priority
value.
Ethernet Type Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q Ethernet type value
(hex 0x0-0xffff) in the packet header.The Ethernet type value may be set in the form:hex 0x0-0xffff,which
means the user may choose any combination of letters and numbers ranging from a-f and from 0-9999.
To view the settings of a previously correctly configured rule, click
View in the Access Rule Table to view the following screen:
Figure 6- 69.Access Rule Display window (Ethernet)
To configure the Access Rule for
Packet Content Mask,open the Access Profile Table and click Modify for a Packet Content Mask entry.This
will open the following screen:
82
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch