Filter
Top Products
This window displays the following information:
Parameter Description
Unit
Choose the Switch ID number of the Switch in the switch stack to be modified.
Port The port number of the reauthenticated port.
Auth State The Authenticator State will display one of the following:Initialize,Disconnected,Connecting, Authenticating,
Authenticated,Aborting,Held, ForceAuth,ForceUnauth,and N/A.
BackendState The Backend State will display one of the following:Request, Response,Success,Fail,Timeout,Idle,Initialize,and N/A.
OpenDir Operational Controlled Directions are both and in.
PortStatus The status of the controlled port can be Authorized, Unauthorized,or N/A.
Note: The user must first globally enable 802.1X in the Advanced Settings window in the Configuration folder before reauthenticating
ports. Information in the
Reauthenticate Ports Table cannot be viewed before enabling 802.1X.
Reauthenticate Port(s) for MAC Based 802.1x
To reauthenticate ports for the MAC side of 802.1x,the user must first enable 802.1x by MAC address in the Advanced Settings window.Click Port
Access Entity > PAE System Control > Reauthenticate Port(s)
to open the following window:
Figure 6- 82.Reauthenticate Ports – MAC based 802.1x
To reauthenticate ports,first choose the switch in the switch stack by using the
Unit pull-down menu,then the range of ports in the From and To field.Then
the user must specify the MAC address to be reauthenticated by entering it into the
MAC Address field and checking the corresponding check box.To begin
the reauthentication,click
Apply.
91
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch