Filter
Top Products
30
3.10 Protocol Configuration
To access the Protocol Configuration Menu, enter the letter r from the Configuration Menu. Use the listed
command letters to configure Simple Network Management Protocol (SNMP) and Spanning Tree Protocol
(STP).
IntraCore 35160-T Protocol Configuration Menu
<Cmd> <Description>
n SNMP Configuration
s Spanning Tree Configuration
q Return to previous menu
root>
3.10.1 SNMP Configuration
To access the SNMP Configuration Menu, enter the letter n from the Protocol Configuration Menu. Use the
listed command letters to configure the community strings, trap authentication, and the trap receiver.
IntraCore 35160-T SNMP Configuration Menu
SNMP Read Community: public
SNMP Write Community: private
Trap Authentication: Disabled
SNMP Trap Receivers:
IP Address Community
1. <empty> <empty>
2. <empty> <empty>
3. <empty> <empty>
4. <empty> <empty>
<Cmd> <Description>
r Set SNMP Read Community
w Set SNMP Write Community
t Toggle Trap Authentication Enable/Disable
a Add/Update SNMP Trap Receiver
d Delete SNMP Trap Receiver
q Return to previous menu
root>
Changing Community Strings
Important! Be sure to change the SNMP community strings in order to prevent unauthorized access to
management information.
To change the switch’s community strings, use the following procedure:
1. Open the SNMP Configuration Menu by typing n in the Configuration Menu.
2. To change the read community string, type r. To change the write community string, type w.
3. At the prompt, type a new community string.
For a description of read and write community strings, see the following table: