Asante Technologies 35160 Switch User Manual


 
77
7.1.3 Port VLAN ID
To allow untagged packets to participate in a VLAN, a Port VLAN ID (PVID) must be assigned in the
relevant port(s).
Each port on the switch has a default PVID of 1 (the default VLAN) and will receive both tagged and
untagged frames. The manager may configure the PVID of any desired port (the range is 1 to 4094). For
ports that have been configured to receive only tagged frames, the PVID is meaningless. If a port is
configured to receive only tagged frames, then any untagged frame received will be dropped. Tagged
frames that are received will be forwarded to the VLAN represented by the VID in the tag header of the
frame.
7.2 Spanning Tree Protocol
The Spanning Tree Protocol (STP) is part of the IEEE 802.1D standard. It provides for a redundant network
without the redundant traffic through closed paths. For example, in a network without spanning tree protocol,
the same message will be broadcast through multiple paths, which may start an unending packet-passing
cycle. This in turn causes a great amount of extra network traffic, leading to network downtime. The STP
reduces a network like this, with multiple, redundant connections, to one in which all points are connected,
but where there is only one path between any two points (the connections span the entire network, and the
paths are branched, like a tree).
7.2.1 How It Works
All of the bridges (a switch is a complex bridge) on the network communicate with each other using special
packets of data called Bridge Protocol Data Units (BPDUs). The information exchanged in the BPDUs allows
the bridges on the network to do the following:
Elect a single bridge to be the root bridge
Calculate the shortest path from each bridge to the root bridge
Select a designated bridge on each segment, which lies closest to the root and forwards all traffic
to it
Select a port on each bridge to forward traffic to the root
Select the ports on each bridge that forward traffic, and place the redundant ports in blocking states
7.2.2 Spanning Tree Parameters
The operation of the spanning tree algorithm is governed by several parameters. The manager should
attempt to set these parameters only if they have experience with the 802.1D specification. To set the
parameters listed below, access the Spanning Tree/Bridge Settings screen (console or telnet), or the
Spanning Tree/Bridge Settings page (in the Web interface).
Bridge Priority
Setting the Bridge Priority to a low value will increase the likelihood that the current bridge will become the
root bridge. If the current bridge is located physically near the center of the network, decrease the Bridge
Priority from its default value of 32768 to make it become the root bridge. If the current bridge is near the
edge of the network, it is best to leave the value of the Bridge Priority at its default setting.
Hello Time
This is the time period between BPDUs transmitted by each bridge. The default setting is 2 seconds.
Maximum Age
Each bridge should receive regular configuration BPDUs from the direction of the root bridge. If the
maximum age timer expires before the bridge receives another BPDU, it assumes that a change in the
topology has occurred, and it begins recalculating the spanning tree. The default setting for Maximum Age is
20 seconds.