Filter
Top Products
56
IntraCore 35160-T VLAN Management Menu
VLAN Version: 1 VLAN Type: Port Based
Max. Supported VLAN ID: 4094 Max. Supported VLANs: 1024
Number of VLANs Configured: 64 Number of Active VLANs: 64
<Cmd> <Description>
v VLAN Group Static Configuration
p VLAN Port Attribute Configuration
d Display VLAN Groups Summary
a Display Port VLAN Attribute Summary
r Reset VLAN Configuration to Factory Default
q Return to previous menu
Command>
4.3.2 Configuring Static VLAN Groups
To access the VLAN Group Static Configuration Menu, type v in the Configuration Menu to access the
VLAN Management Menu, then type v again to access the VLAN Group Static Configuration Menu. A
screen similar to the following appears:
IntraCore 35160-T VLAN Group Static Configuration Menu VID:[0001]
Name: Default VLAN Created By: Mgmt
Mgm Access: Enable Status: Active
Port List 1 8 9 16
======== ========
++++++++ ++++++++ +: static
d: dynamic
-: Not Member
<Cmd> <Description> <Cmd> <Description>
c Create VLAN r Remove VLAN
e Set VLAN Name t Toggle Mgmt Access
m Move ports to this VLAN d Delete Port Members
o Overlap Ports To This Vlan f Display Vlan-Grp Information
l Toggle To Vlan-prt Config Menu
Command>
S)elect VID N)ext VLAN P)rev VLAN H)elp Q)uit
Navigate to the desired VLAN to configure by typing a command (s, n, or p) as shown at the bottom of the
screen. With the Select command, select a VLAN by its VLAN ID (VID); type the VID of an existing VLAN, or
the VID of a VLAN you will create.
Creating a VLAN
Follow the steps below to create a new VLAN:
1. Type c from the VLAN Group Static Configuration Menu.
2. Type s to select the VLAN, and then enter the VLAN ID (VID) that has been chosen for use. Notice
that the VID for an unused VLAN is 0000.
3. Press Enter.
4. Type e to set the VLAN name (up to 32 characters) and press Enter.
5. Type m to select the ports to be assigned the VLAN.
To make more than one assignment, separate each one with a comma. For example, 8,11
specifies ports 8 and 11. To specify a range of ports, use a hyphen. For example, 1-3, 8, 11
specifies ports 1, 2, 3, 8, and 11. See Help for more information about specifying units and ports.