Filter
Top Products
Installation and Set-up
Page 2-4
always check.
❑ Do not perform any action that creates a potential hazard to people
or makes the equipment unsafe.
❑ Carefully examine your work area for possible hazards such as moist
floors, ungrounded power extension cables, and missing safety
grounds.
❑ Never install telephone jacks in wet locations unless the jack is specif-
ically designed for wet locations.
❑ Never touch uninsulated telephone wires or terminals unless the tele-
phone line has been disconnected at the network interface.
❑ Never touch uninsulated telephone wires or terminals unless the tele-
phone line has been disconnected at the network interface.
Power Requirements
The source electrical outlet should be installed near the IntraChassis 9000 and
easily accessible. It must also be properly grounded.
Make sure the power source adheres to the following guidelines:
❑ Voltage range: 100 to 240 VAC
❑ Frequency range: 60/50 Hz
❑ Maximum current: 10 A per power supply at 110 volts
Environmental Requirements
The IntraChassis 9000 must be installed in a clean, dry, dust-free area with
adequate air circulation to maintain the following environmental limits:
❑ Temperature: 0° to 40° C (32° to 104° F)104°
❑ Relative Humidity: 5% to 85% non-condensing
Avoid direct sunlight, heat sources, or areas with high levels of electromagnetic
interference.
Cooling and Airflow
Do not restrict air flow by covering or obstructing air vents on the sides of the
chassis.
GLXY9.book Page 4 Thursday, February 17, 2000 3:04 PM