Filter
Top Products
Basic Configuration
Page 3-10
3 Type b to set the Boot Mode to BootP-TFTP, or type t to
set Boot Mode to TFTP only. If you choose BootP-TFTP
mode, the options for setting the IP Address of the TFTP
server and the Boot File Name become unavailable; in this
case, skip Steps 4-7 and go on to Step 8.
4 Type s in the Bootstrap Configuration Menu, to select the
option Set Boot Server IP Address.
5 At the prompt, type the IP address of the remote boot server
which contains the switch’s software image file. Then press
Return. The Bootstrap Configuration Menu appears.
6 Type f to select the option Set Boot File Name.
7 Type the software’s file name/network path at the prompt.
8 Press Return.
◆ Note: If you decide to use Local Load Mode rather
than Remote, type l. The Local Bootstrap Configura-
tion Menu appears, as shown in Figure 3-3.
The IntraChassis 9000 is now set to download its software remotely from the
network. This will occur the next time the unit is powered on or reset.
GLXY9.book Page 10 Thursday, February 17, 2000 3:04 PM