Filter
Top Products
Installing Second Power Supply
Page 2-11
Installing GBIC Interfaces
If you have installed modules for GBIC interfaces, install each interface itself by
sliding it into the port, until the locking tabs on either side of the GBIC
interface unit click into the locked position. You can then connect the SC-type
fiber media.
To remove a GBIC interface, squeeze the locking tabs against the sides of the
unit until they release it, then slide the interface out of the port.
Installing Second Power Supply
To install a power supply module in your IntraChassis 9000, first loosen and
undo the thumbscrew holding the cover plate, then remove the plate and slide
the second power supply into the chassis from the front, as shown in Figure 2-2.
Tighten the thumbscrew to hold the power supply firmly in place.
Connecting Power
To connect power to the IntraChassis 9000, use the following procedure.
▲ Important: Carefully review the power requirements on
page 2-4 before connecting power to the IntraChassis 9000.
1 If you have purchased a second power supply, insert it in the
bay provided at the bottom of the IntraChassis 9000 chas-
sis, as shown in Figure 2-2.
2 Plug one end of the supplied power cord into the power
connector on the back of the unit.
3 Plug the other end into a grounded AC outlet.
▲ Important: If the power does not come on, refer to
Appendix A, “Troubleshooting.”
The IntraChassis 9000 is ready for connection to the network.
GLXY9.book Page 11 Thursday, February 17, 2000 3:04 PM