Filter
Top Products
Configuring for Management
Page 2-15
Connecting To a Console
Use the following procedure to make the cable connection from a terminal to
the console port on the Management Engine of the IntraChassis 9000.
1 Using a straight-through RS-232 cable with a 9-pin male
D-subminiature plug at one end, connect a terminal or
workstation (PC or Macintosh) running a terminal emula-
tor to the Console port on the front of the IntraChassis
9000.
2 Make sure both units are powered on.
If using a PC with a terminal emulator, make sure it is con-
figured with the following terminal settings:
❑ Baud: 9600
❑ Data Bits: 8
❑ Parity: None
❑ Stop Bits: 1
❑ Flow Control: None
3 Once connected, the Local Management Main Menu
appears on the terminal screen.
For further information on setting an IP address for configuration of a terminal,
or a PC running a VT100 terminal or emulator (such as HyperTerminal,
ProComm, or ZTerm), see “System IP Configuration” in Chapter 3.
GLXY9.book Page 15 Thursday, February 17, 2000 3:04 PM