Filter
Top Products
QLS-4100 X 16
Installing the Unwind Mandrel
Your QLS-4100 X was shipped with the Media Unwind Mandrel uninstalled to
protect it from damage during transit. The mandrel is easily installed by following
the procedure outlined below.
Tools Needed
1/8” Allen Wrench
Slide the media unwind mandrel onto the shaft until the backplate flange is seated
firmly against the collar located on the inside of the shaft. The outside of the shaft
should be flush with the surface of the mandrel.
Firmly tighten the supplied Allen set screw against the shaft.
1
2