Filter
Top Products
QLS-4100 X 60
System Upgrade
Selecting System Upgrade causes the printer to reset itself in preparation for a
firmware upgrade. This procedure is performed infrequently, and requires a PC
computer and QuickLabel Systems’ upgrade software. If it is necessary to per-
form a system upgrade, refer to the instructions that are included with the upgrade
software.
To initiate a firmware upgrade:
Press the PRINT/PAUSE key until the printer is in the paused state.
Press the NEXT or PREVIOUS key until the Sys Upgrade menu is displayed.
Press the SELECT key to confirm that you wish to perform a firmware upgrade.
The printer will display the following:
Press SELECT again if you are certain you wish to perform a firmware upgrade.
The printer will then initiate a power on reset sequence and will display the follow-
ing at the end of the sequence.
This message indicates that the printer is ready to receive firmware data from the
upgrade utility program. During the download process the data LED will flash and
the display will show:
Pause: Sys Upgrade
Press SELECT
1
2
3
4
Pause: Sys Upgrade
SELECT to Verify
BEGIN pDATA TRANSFER
cycle power to quit
DOWNLOAD IN PROGRESS