Filter
Top Products
QLS-4100 X 37
Press the SELECT key. The display will show the following prompt:
Press and hold the FORM FEED/ADVANCE key until the reflective mark is posi-
tioned behind the Media Sensor Assembly and in close proximity to the guide
arrow indicated on the center plate.
Press the SELECT key and observe the Reflective mark size on the display.
If calibration was successful, the following message will be displayed:
If calibration was unsuccessful, the following message will be displayed:
The printer will then re-initiate the calibration procedure.
After successful calibration, press the PRINT/PAUSE key to return the printer to a
Ready state.
Pause: Reflective
Calibration OK
10
11
12
13
Place Mark @ Arrow
Then Press Select
Pause: Reflective
Calibration Bad