Filter
Top Products
QLS-4100 X 17
Locate the AC Power Input at the bottom of the rear panel.
Plug the power cord into the printer. Be sure to use only the AC Power Cord
supplied with the printer.
Connect the opposite end of the AC Power Cord into an earth grounded AC recep-
tacle. Do not power the printer on until you have finished making the remaining
connections described in this chapter.
Warning
Do not use any type of receptacle adapater or AC Power Cord that has not
been supplied with the unit. Doing so can result in damage to the printer.
Note
The printer has been set at the factory for the correct line voltage for your
country. The voltage setting can be viewed in a window at the top of the
AC Power Input. If this setting needs to be changed, refer to the
procedure in Chapter 7 of this manual
Note
It is recommended that an AC line conditioner / surge supressor is used.
Select a unit that is capable of handling the power requirements of the
printer and protecting from surges and spikes.
Power Connection
1
2