Filter
Top Products
QLS-4100 X 69
The following pages show a number of possible error messages that may be en-
countered during operation. Instructions are provided on how to clear the condi-
tion that caused the error message to be displayed.
• The label or tag media has been consumed. Reload a new roll of media.
• The printer has not been properly calibrated. Recalibrate for the proper media.
• The sensor has been repositioned off of the gap or notch. Ensure that the sensor
position is correct and recalibrate if necessary.
• The media is not making positive contact with the Media Travel Roller or the
media travel roller is not turning freely. Ensure that the roller spins freely and that
the media is making contact with the roller causing it to turn at a regular rate.
• The printer requires media recalibration.
• The printer is out of ribbon on one or more print stations. Reload a new roll of
ribbon on the indicated print station(s).
• The ribbon unwind is not turning at a steady rate. Ensure that the ribbon has been
loaded correctly and that the ribbon unwind tension has not been set too high.
After reloading media or ribbon, the printer will reprint any label formats that were
partially under the print stations when the error occured.
Note
Media Out or Film Out errors can occur if either the media or film is not
feeding, winding or unwinding properly. A physical adjustment to the
media path or film tension usually corrects this condition. In order to
resume printing, you must raise and lower at least one printhead to clear
the internal error.
ERROR: Media out or
sensor is off media
Ribbon Out !!!
TTR 1
Error Messages