Filter
Top Products
QLS-4100 X 24
DIP Switch Settings
Located on the rear panel of the printer are a series of small switches used to set
various communication parameters and option settings. Use a small, blunt pointed
object like a pencil to change the position of these switches.
Use the instructions below and the table on the next page to set the
dip switches for your printing requirements.
DIP Switch Function
1 & 2 RS-232 Serial Baud Rate
3 RS-232 Handshaking
4 Parallel or Serial Communication
5 & 6 Not Used (Factory Set to Off)
7 Cutter and Cutter/Stacker Option
8 Standard or Windows Host Mode
Note
If changes are made to DIP switch settings while the printer is powered
on, the power must be cycled for the changes to be recognized.