Filter
Top Products
5-18 BE-1204B-BC • BE-1206B-BC
Chapter 5 Editing Embroidery Data
! The number for repetition is 1 to 100 for both vertical (Row) and horizontal (Column) directions.
! The unit for repetition can be set in inches. To use the inch unit, set the length to [inch] on the
[Configuration] of Tool menu of the machine controller. (→ page 6-24)
! The pattern connection can be set in "Direction" as follows:
From top left, alternating directions From top left, left to right direction
W0716Q W0717Q
From bottom left, alternating directions From bottom left, left to right direction
W0718Q W0719Q
1. Select [Repeat] from Edit menu or click .
2. Specify the number, interval and direction of repetition.
W1033Q
3. Click [OK].
The value can be directly entered.
Click here to increase/decrease the value.
Repeat count in the
longitudinal direction
Repeat count in the
lateral direction
Select the direction of repetition.
Sets margins of the sewing area used for
the calculation of the repetition number in
the automatic setting.
A
ll patterns created in repetition are grouped as a single pattern.
Longitudinal distance (Unit: 0.1 mm or 0.01")
Lateral distance (Unit: 0.1 mm or 0.01")
The number is set automatically so as the number of
repetitions to be the maximum within the sewing area.
Select the reference position for spacing.