Filter
Top Products
11-2 BE-1204B-BC • BE-1206B-BC
Chapter 11 Error code list
Code Error Measures
E-00 No error occurs.
E-01
Either motor of main shaft, X- or Y-axis, or
lower shaft has locked.
E-02
Overtravel occurs during home position
detecting movement.
This is not usually displayed.
E-03
The stop switch is pressed during home
position detecting movement.
Press the
or turn on the F/B switch on the head to either
side to restart the home position detecting movement again.
E-04 Home position detection out of range This is not usually displayed.
E-05 Needle stop position error
Adjust the pulley stop position (100 degrees) above the needle
and press the
or turn on the F/B switch on the head to
either side.
E-06 Needle bar case position error
Adjust the position of needle bar case manually, then press the
or turn ON the F/B switch on the head to either side. If the
same error occurs again, the color change proper position
sensor is faulty.
E-07 Needle bar case lock
Press the
or turn on the F/B switch on the head to either
side. If the same error occurs again, the color change
mechanism is faulty.
E-08
Stop switch or emergency switch was pressed
while the needle bar case is traveling.
This is not usually displayed.
E-09 X-axis home position detection error
Turn the power off and on once. If the same error occurs
again, the X-axis mechanism is faulty.
E-0A Thread breaking error
After passing through the thread, press the
or turn on the
F/B switch on the head to either side.
E-0B Stop or emergency stop during sewing This is not usually displayed.
E-0C Lower thread broke during embroidering.
After the replacement of the lower thread, press the
or
turn ON the F/B switch on the head to either side.
E-0D
The machine does not return to the home
position.
E-0E Mending finish
This is not usually displayed.
E-0F Failed in the reading of needle bar No.
Press the
or turn ON the F/B switch on the head to either
side. If the same error occurs again, the I/O CPU
communication is faulty, or the color change position sensor is
faulty.
E-10 Abort by the beam sensor ON
Press the or turn ON the F/B switch on the head to either
side.
E-11 Failed in the reading of X home position sensor
Press the
or turn ON the F/B switch on the head to either
side. If the same error occurs again, the I/O CPU
communication is faulty.
E-12 Failed in the reading of X home position sensor
Press the
or turn ON the F/B switch on the head to either
side. If the same error occurs again, the I/O CPU
communication is faulty.