Filter
Top Products
7-2 BE-1204B-BC • BE-1204C-BC • BE-1206B-BC
Chapter 7 Operation of Machine
1. Operating Procedures
1-1 Power Source
W1262Q W1265Q W1405Q W1266Q
1. Turn on the main power switch.
2. Reset the emergency stop switch.
3. Change the Flat / Cap hoop select switch according to the hoop to be used.
4. Press the power switch.
5. The power lamp lights up and the display window indicates "1204” (BE-1206B : "1206")".
BE-1204B-BC BE-1206B-BC
BE-1204C-BC
W1355Q W1356Q
6. The alarm sounds three times and the needle bar move upward. Then the hoop moves to the
home position and the sewing data screen is displayed.
When turning the power off and back it on again, wait for at least 10 seconds.
1-2 Preparation for Embroidering
1. Select embroidering data while the machine is in the waiting state for an embroidering data
selection, and transmit required data by pressing the
icon.
2. The READY lamp lights up and the machine is placed in the waiting state.
3. Pressing
, determine a position to start embroidering.
An error code is displayed in the display window if a pattern comes out of the hoop.
4. Pressing starts embroidering.
During embroidering, the speed is indicated in the display window.
5. After embroidering is finished, the machine is placed in the stand-by state.
Emergency stop switch
Power switch
Flat / Cap hoop select swich
Main power switch